Crate BT1000 BT Series 12" Bass Combo Amplifier Amp

If you're ready for a truly professional quality bass rig, the Crate BT1000 is ready to help you conquer the stage. The onboard 4-band EQ allows you to fine-tune the critical midrange frequencies, bringing out your instrument's true voice and BT1000's convenient tilt-back design allows you to put the sound right where you want it. Our proprietary Expander makes the BT1000 a soloist's dream; use its controls to set your solo volume level and tone independently of the clean channel and when the time comes, simply tap the footswitch to raise the roof. You can also use the Expander for dramatic tone changes, like switching from finger-style to slap.

A built-in Limiter keeps your sound clean even at full output power levels, and an effects loop is provided for adding your favorite effects. And when it comes to sending your signal to the front-of-house or a recording console, the BT1000 gives you total control. Not only do you have a Balanced XLR Line Out with Level control, but you can select pre- or post-EQ send. There's even a ground lift to eliminate those nasty interconnection hum problems that can ruin a gig or recording session. And its tilt-back cabinet design lets you angle the combo toward you so you can feel the air you're moving.

With 100 watts of RMS power, a powerful custom-designed 12" speaker, and a full compliment of professional features at your back, the Crate BT1000 just might remind you why you chose to play bass in the first place!

Crate 12" special design bass driver 100 watts RMS Multi-angled, tilt-back monitor design 1/4" input with mute and -15dB pad Clean level control with 4-band EQ Expander circuit with slope and level controls

Specifications:

• Output Power Rating: 100W RMS 2% THD, 4 , 120 VAC
• Gain
  • Clean Channel: 56dB
  • Expander: 62dB
• Tone Range
  • Low: 20dB @ 50Hz
  • Lo Mid: 24dB @ 150Hz
  • Hi Mid: 18dB @ 1kHz
  • High: 32dB @ 10kHz
  • Expander: 22dB @ 330Hz
• Signal To Noise Ratio: 65dB below full power, tones flat, gain and level @ "10"
• Maximum Input Signal Level Accepted: 15 volts peak-to-peak
• Balanced Line Out Jack: 2 volts peak-to-peak @ full rated power w/600 ohm load
• Internal Speaker
  • Size: 12"
  • Type: Crate Custom
  • Magnet: 28.5 oz
  • Voice Coil: 1.5"
  • RMS Rating: 100 watts
  • Impedance: 4 ohms
• Input Power Requirements
  • 120 VAC, 60Hz, 115VA
  • 100/115VAC, 50/60Hz, 115VA
  • 230VAC, 50/60Hz, 115VA
• Size: 19-1/4" H x 15" W x 16" D
• Weight: 53 lbs